Volume pot part number for a tower model?

[DejahThoris]

Does anyone happen to have the part number for the volume pot on tower models?

Previous owner mangled the pins on mine.

[PHD]

I think it's basically a Dual 10k Ohm Alps potentiometer similarly to this one

https://tech.alpsalpine.com/prod/e/html/potentiometer/rotarypotentiometers/rk09k/rk09k12a0a2k.html

but with a smaller stem, probably specially made for sharp or no longer produced.

I have replaced the one in my Expert by modifying the stem.

[dankcomputing]

The stem on that part is way too big to really modify. How did you cut it down?

I thought about just cutting the assembly open and just swapping the shaft over but the old shaft is what actually broke.

It might be possible to 3d model and print a new knob that will fit, but that would be something of an ordeal.

[dankcomputing]

Turns out that you can cut it down through careful and measured flushcutter abuse:

Installed it and it works great. You may want to order more than one pot in case you mess up - in my case I had to file the connecting end of the knob down very slightly.