Genesis 2 on a PVM-1350

Started by andy251203, June 06, 2013, 12:50:33 PM

Previous topic - Next topic


I'm trying to get RGB hooked up to my Sony PVM-1350 monitor and I keep getting a washed out image. Tried using 75 ohm resistors, and then tried using 75 ohm + 220uf capacitors in line. No change in the picture. Here's what I'm looking at:

Anybody have any ideas? I've run the RGB lines to an arcade monitor in the past and it looks fine, perhaps a bit dark, but the brightness can be turned up on the arcade monitor to compensate.


The first thing I'd check is if have a ground connection from the console to the monitor.  The 9 pin mini din shell can be hard to solder to...