nfg.forums

NFG Forums => RGB + Video Discussions => Topic started by: lecarde on January 03, 2010, 03:23:49 PM

Title: Genesis 2 RGB encoder replacement
Post by: lecarde on January 03, 2010, 03:23:49 PM
Hey all, I just got a Genesis 2 from the thrift store and I'm looking to do some mods to it.  I ordered all the parts for the s-video mod, but after I opened it, I realized it is a model with a Samsung KA2195D.  I have an extra CXA1645M I pulled out of a PS1, and looking at the datasheets, it appears they are pin-compatible.  However, I just wanted to run it by everyone to see what you think.
Title: Re: Genesis 2 RGB encoder replacement
Post by: viletim on January 05, 2010, 11:55:41 PM
Yes, it's a drop in replacement. One small exception is pin 18: it's not connected on the KA2195D, but the CXa1645 should have a 20k (NTSC) or 16k (PAL) resistor to ground.
Title: Re: Genesis 2 RGB encoder replacement
Post by: alex... on July 31, 2011, 10:44:11 PM
I have Genesis 2 with video chip samsung ka2195d, motherboard va0
I replace ka2195d to cxa1645m

Doing so:
8 leg left hanging in the air
9 leg through a capacitor to ground hooked 0.1mkf
18 leg through a resistor to ground hooked 20kOm
the other leg is soldered as is
photo

before
http://imageshack.us/photo/my-images/42/p10008812.jpg/ (http://imageshack.us/photo/my-images/42/p10008812.jpg/)

after
http://imageshack.us/photo/my-images/4/cxah.jpg/ (http://imageshack.us/photo/my-images/4/cxah.jpg/)

As a result of the genesis of the issue now is not no video or sound. Have any ideas how to fix it?

P.S. Sorry my Englesh not good