Getting BlueSCSI Ver 1.1 STM32 to work.
CZ-600 CE and Pro units are default set to SCSI ID 0 internally. After setting switch.x and bootset to default memory location, and delay to 1-5 seconds you can connect and use a bluescsi. BEWARE of STM32 Blue pill FAKE. Run BlinkyTest attached. If the board fails, get another.
Using the Japanese Firmware attached from ArcSCINO on the STM32, and put both jumpers on the board on.
The BLUE scsi will need power to the floppy connector on the PCB, so I splice a floppy power cable onto the internal floppy Power cable and poke it out the scsi hole in the case. JUST 5v and ground, dont wire the 12v, and i would high suggest removing this from the cable completely.
I make a short cable with centronics 50pin male and 50 pin idc 3cm long. See attached picture.
On the SDCARD, place the scsi-config.txt file in the root directory with the images.
I use HD10_512.hda (Boot image) which is the SCSI ID 1 image, and all subsequent images are named HD20_512.hda, HD30_512.hda etc...... Drive allocation is in image SCSI ID numeric order.
This will then boot with the ipl boot on startup.....
My floppy drives where good, but I would highly suggest https://github.com/aotta/X68KFDPi2W
i have built and it works.
Here is a guide on floppy repair.
https://nfggames.com/forum2/index.php?topic=6914.0
But remember, with a working bluescsi, you will hardly use the floppy drives.
Hope this helps.
POCOAUST