It migth sound stupid but I can't get rid of the LED cable in my Mega Drive, I want to mod it, and it is really anoying ;) How can I safely remove it and put it back?? from the board or from the led?
also, for drilling the cases, what do you recomend me??
I have a Dremmel tool, but I think I can't use it because can't use drill bits of more than 3,6mm, and switches require more.
Thanks again! ;)
I just melted the stupid little platic part that holds the LED in...
Then later I soldered it back onto the mother board (without the plastic part).
Thanks Martin. I'll work something out.
what about drilling?
To remove mine I first removed the large plastic ring that goes around the top of the MegaDrive. There are a few 'posts' inside where the ring was put on, and then melted to hold it in place. I used a dreme to cut these melted bits off.
As for drilling, any drill + bit will do (sharp ones, obviously. Cement bits are NOT a good choice!).
Well, not any drill. I mean, how thick does it have to be?? 5 mm ??
well, no offense, but it's YOUR switch, how would I know how big it is?
Well, I meant a standar switch, those that appear in almost all pictures. anyway you're right, it was a dumb question :)