nfg.forums

NFG Forums => RGB + Video Discussions => Topic started by: andy251203 on June 06, 2013, 12:50:33 PM

Title: Genesis 2 on a PVM-1350
Post by: andy251203 on June 06, 2013, 12:50:33 PM
I'm trying to get RGB hooked up to my Sony PVM-1350 monitor and I keep getting a washed out image. Tried using 75 ohm resistors, and then tried using 75 ohm + 220uf capacitors in line. No change in the picture. Here's what I'm looking at:

(http://img.photobucket.com/albums/v281/andy251203/20130605_223658_zpsbb2b9c4c.jpg)
(http://img.photobucket.com/albums/v281/andy251203/20130605_223638_zps740093af.jpg)
(http://img.photobucket.com/albums/v281/andy251203/20130605_223627_zpsd5b47187.jpg)

Anybody have any ideas? I've run the RGB lines to an arcade monitor in the past and it looks fine, perhaps a bit dark, but the brightness can be turned up on the arcade monitor to compensate.
Title: Re: Genesis 2 on a PVM-1350
Post by: RGB32E on June 09, 2013, 12:32:19 AM
The first thing I'd check is if have a ground connection from the console to the monitor.  The 9 pin mini din shell can be hard to solder to...