Has anyone ever tapped the RGB lines inside of a Famicom Titler who could give me careful, specific, step by step instructions?
This is very rare, old, expensive hardware so I don't want to screw it up. Also if there are other things I can practice on that would be great.
At least the correct PPU is already in the system by default so tapping the lines should be a lot simpler. I can take pictures, just looking for help if anyone is interested in seeing the inside of a Famicom Titler.
Chris Covell did it with his: http://www.chrismcovell.com/gotRGB/fctitler.html (http://www.chrismcovell.com/gotRGB/fctitler.html)
It looks like you just wire up the RGB lines from the points shown and then connect them to 75 ohm resistors for the final output.
Chris use my diagram and stolen two pictures ;) But I allow them when he send the Rockman Proto ROM, hehe...