nfg.forums

NFG Forums => Console Mods => Topic started by: Simon Stoneman on April 05, 2006, 05:54:13 AM

Title: Converting GC digital cable to component
Post by: Simon Stoneman on April 05, 2006, 05:54:13 AM
Has any one tried to convert the GC digital cable with the jap d-terminal connector to a component type i.e. 3 rca connectors Y Pb Pr as the proper componet cable is become few and far between to get at a decent price :angry: .

As here (http://www.gamesx.com/avpinouts/jdcon.htm) shows the pin config for the d-terminal but o wouldn't know where the other wires would go and thoughts or leads?

Thanks,

Simon.  
Title: Converting GC digital cable to component
Post by: NFG on April 05, 2006, 07:38:04 AM
If the only signals you want are the component ones, just ignore the other ones.  Pins 1-6 are all you need.
Title: Converting GC digital cable to component
Post by: Simon Stoneman on April 06, 2006, 04:47:27 PM
Cheers for the info, one other question, pin 14 which has the plug in flag do you happen to know were this would be placed out of the 3 rca's I would have as it would be neat to use it?

Simon.  
Title: Converting GC digital cable to component
Post by: NFG on April 06, 2006, 10:47:44 PM
It probably needs to be grounded, but there's the off chance it'll need positive voltage.  It's a signal to the TV, not the console.