nfg.forums

I don't have an XVI but the Expert has separate potentiometers for each colour, so I assume the XVI has them too.

Quote from: kanjiology on Today at 12:25:41 AMIt's just a DIN-8 cable, you can buy them anywhere. I used this one: https://www.amazon.com/gp/product/B0794WSGN9/

Thanks, I'll order the same!
Except shutting down the monitor with the computer, it this allowing something else?

Quote from: Jehuty on Today at 01:52:56 AMi am a little bit sceptical if that cable would solve my problem. It seems that in the cable is a active sync combiner like in the UMSA.
Yesterday i tried the XVI on an Grundig CRT TV and there are the colors right, with the same cables.
So, the CZ-600 works on Sony and Grundig while the XVI only works on the Grundig. Sadly i wanted to use the XVI with the Sony.

From what you tell me, I think it's your Sony TV, which now doesn't work as well as it should.

i am a little bit sceptical if that cable would solve my problem. It seems that in the cable is a active sync combiner like in the UMSA.
Yesterday i tried the XVI on an Grundig CRT TV and there are the colors right, with the same cables.
So, the CZ-600 works on Sony and Grundig while the XVI only works on the Grundig. Sadly i wanted to use the XVI with the Sony.

It's just a DIN-8 cable, you can buy them anywhere. I used this one: https://www.amazon.com/gp/product/B0794WSGN9/

Don't know why but updated to the last HDD image and my phantom drives problem went away the drive swap that i was adding to the autoexec was not necessary.

Quote from: z964 on May 22, 2024, 11:04:14 AMI tried a 23mm ball bearing from this ebay seller: https://www.ebay.com/itm/335131689684?var=544365350519

It works better than an original mouse ball for me, but sure does make the mouse a lot louder.

Thanks!

I tried a 23mm ball bearing from this ebay seller: https://www.ebay.com/itm/335131689684?var=544365350519

It works better than an original mouse ball for me, but sure does make the mouse a lot louder.

brandish MAME 0.260 Software List ROM
legend of heroes 1 and 2 arhive.org  RAW DUMP

Now that I'm using my x68k with the original monitor I would like to use the TV Control feature.
I saw the cable is CZ-6CT1, anyone know the pinout or the reference of a compatible cable that I can use?

Thanks