« previous next »
Pages: [1]

Author Topic: Some clarifications on the signal separator  (Read 1163 times)

madmalkav

  • Guest
Some clarifications on the signal separator
« on: January 27, 2004, 07:24:22 pm »
So, I get the 3DO video composite cable, solder it to the LM1881, and I get a clean sync signal. Now, where do I solder that? In component mode, SCART connectors don't have a sync input, as far as I know, so how am I supposed to use this signal?

[Edited: previous version of this message was confuse, retard english. Not like this is too much better, but...]
« Last Edit: January 27, 2004, 07:51:02 pm by madmalkav »
Logged

Offline Lawrence

  • Administrator
  • ThrobbingMember
  • *****
  • Posts: 3055
    • NFGgames
Some clarifications on the signal separator
« Reply #1 on: January 27, 2004, 08:28:38 pm »
What are you trying to do with it?  The 3DO doesn't output RGB or, AFAIK, component video.  Why do you want composite sync??
Logged

madmalkav

  • Guest
Some clarifications on the signal separator
« Reply #2 on: January 27, 2004, 08:45:14 pm »
Cuz I'm a poor idiot. Two hours and 3 coffees later I understood that. I have to stop trying to think in the morning. Sorry for bothering. I have just get to the conclusion that for as low as 30$ I can get an NTSC to PAL60 converter that will take out all my headaches and my sutipd posts. Thanks again and sorry for this stupid post.
Logged
Pages: [1]
« previous next »