I was wondering if the connector for CN6 and CN7 were standard connectors that I could buy online somewhere, or if they are proprietary. Also, if I was able to get a connector, would I need any additional hardware to connect a dreamcast controller to the arcade board, or would I simple have to right the appropriate wires from the Maple Bus, to the right pins in the controller port
(http://2.bp.blogspot.com/-wPIVZ8j_tOE/T0E1T5Ha1hI/AAAAAAAABHo/n01CiHuGN-U/s1600/Naomi_Repair_1.JPG)
(http://1.bp.blogspot.com/--l4W-YGTtHE/TsEGcTfozEI/AAAAAAAAAIM/Du3WEC4oR4c/s1600/dcpinout%2B3.PNG)
would something like this do the trick?
http://www.allelectronics.com/make-a-store/item/con-2410/10-pin-connector-w/header-0.1-spacing/1.html (http://www.allelectronics.com/make-a-store/item/con-2410/10-pin-connector-w/header-0.1-spacing/1.html)
EDIT:
hmm, is this the same connector used for kick harnesses?
EDIT 02:
so maybe this?
http://www.jammaboards.com/store/capcom-cps-ii-cps-iii-naomi-auxiliary-kick-harness-capcom-h2.html (http://www.jammaboards.com/store/capcom-cps-ii-cps-iii-naomi-auxiliary-kick-harness-capcom-h2.html)
EDIT 03:
if no additional circuitry / logic is needed I could probably wire it directly to this
http://www.partrecipe.com/web/Sega_Dreamcast_Controller_(female) (http://www.partrecipe.com/web/Sega_Dreamcast_Controller_(female))
does anyone know of a list that shows what Naomi games support the maple bus in place of standard JVS I/O